How to: Mod servo for continous rotation

0 Просмотры
Издатель
A video I made on how to modify a Futaba S3003 servo for continuous rotation

You'll need a few tools:

- small phillips screwdriver
- very small flat bladed (jewellers / precision) screwdriver
- A cutting blade or dremmel with cutting disc
- 4mm drill bit & (ish) drill bit
- Optional: Small wire cutters

This method may work on other servos - if the drive gears are similar. I was lucky enough to get these from an RC plane I wasn't flying. The tail fin snapped off so I thought I'll pull out the servos and found 4 of these :)
Категория
Боевики
Комментариев нет.
Яндекс.Метрика